Bus 168 DIY Kit

A DIY installed version of the power and sync bus board used in our Vessel 168 EuroRack case.

• Screw terminal power entry supporting up to 10 Amps of current
• 28 individually filtered 12V power output connectors 
• 14 individually buffered sync distribution outputs 
  

Included in the box:

• Assembled 168HP bus board with screw terminal connections for power input and power switch (optional).
  
• Chassis mount 2.5mm DC barrel connector with pigtail leads.
• 4x M3 8mm mounting screws.

Not included:

• TT Electronics PEAMD120-12-B2 12V 10A power supply w/EMI filtering and 2.5mm DC barrel connector

Notes:

• As supplied, all you need to do is connect a 12V power supply and ground to the screw terminal marked for power input.
• The mounting standoffs can be used with any M3 screws if the supplied screws are too short.  The four mounting locations are positioned 4.8 inches (24HP) apart.
• Optionally, you may remove the jumper link installed in the screw terminal marked for power switch.  An external shorting switch may be used -- this connection is a remote control, so a high current switch or wiring is not necessary.
• You should use a 2.5mm DC connector like the one supplied, if you're expecting to draw more than 3 amps through the bus board.